HOME 7.3 RELAY AND FUSE BLOCK GENERAL The relay/fuse block assembly consists of two relay/fuse blocks and is located under the right side cover and the rear seat. All relays and fuses (with the exception of the main battery fuse - see 7.4 MAXI-FUSE ) are contained in these two relay/fuse blocks. sm00961 NOTE If motorcycle is ABS equipped, the fuse will be located between the SPARE and IGNITION fuses in the fuse block that is located behind the right side cover. RELAY/FUSE BLOCK REMOVAL 1. Remove right side cover and maxi-fuse. See 7.4 MAXI- FUSE . Figure 7-2. Front Relay/Fuses 2. Open seat. relay/fuse block. Push gently down on the fuse body until it bottoms out in the socket. Figure 7-3.
Rear Relay/Fuses NOTES • Two spare fuses are located in the left relay/fuse block. • If ABS equipped, ABS fuse will be located between spare and ignition fuses in front fuse block. sm01330 SPARE P&A IGN 15A 2A MAX FUEL PUMP SPARE IGNITION SECURITY RELAY 15A 15A 15A 15A LIGHTS SYSTEM 15A FAN RELAY 15A START RELAY BATTERY ACCY 15A 15A ECM Always use replacement fuses that are of the correct type and amperage rating. Use of incorrect fuses can result in damage to electrical systems. (00222a) [61] [62] FRONT REAR (located under passenger seat) (located under right side cover) Use only automotive type ATO fuses as replacements. NOTE RELAY REPLACEMENT Figure 7-4.
Relay/Fuse Blocks (NON-ABS shown) 1. See Figure 7-4 . If a relay is diagnosed as defective, grasp the body of the relay and with a gentle rocking motion, pull straight out of the socket. RELAY/FUSE BLOCK INSTALLATION 2. Line up the pins of the 3. Remove air box cover. See 1.5 AIR CLEANER AND EXHAUST SYSTEM. 4. See Figure 7-2. Gently lift up each relay/fuse block cover release tab (2) and slide each relay/fuse block assembly out of the cover. FUSE REPLACEMENT 1. See Figure 7-4. Grasp the suspect fuse and gently pull straight out of the fuse socket. 2. Inspect the fuse element. Replace the fuse if the element is burned or broken. 3.
Line up the pins of the fuse with the socket holes in the sm00962 tly pull lement in the 1. See Figure 7-2. Slide each relay cket. into relay/fuse block cover. Push e new relay with the socket holes in into the cover until cover releas Push gently down on the relay body 2. Replace air box cover. See 1 the socket. EXHAUST SYSTEM. 3. Turn ignition switch to the FUE Then turn ignition switch to the : Electrical /fuse block assembly back relay/fuse block assembly e tab locks into place. .5 AIR CLEANER AND L position and close seat. LOCK position.