2009 — Installation

HOME 7.5 VOLTAGE REGULATOR GENERAL The voltage regulator is mounted on the lower front radiator cover. sm04847 The voltage regulator cannot be repaired. Replace the unit if it fails. NOTE REMOVAL 1. Remove right side cover and Maxi-Fuse. See 7.4 MAXI- FUSE . To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before pro- ceeding. (00251b) Figure 7-7. Voltage Regulator Internal Mounting Points 2. Remove left and right radiator trim covers. See 1.6 RADI- ATOR SIDE COVERS . 5. See Figure 7-7 . Remove fasteners from regulator mounting points and remove regulator from front cover. 3. Cover front fender with shop towel or protective cover.

Remove fasteners and washers on each side of radiator cover. Remove radiator cover with chrome inlet bezels attached. INSTALLATION 1. See Figure 7-8 . Attach new voltage regulator to front cover with two mounting fasteners. Tighten to 6-10 Nm (53-88 in-lbs ). NOTE Before removing voltage regulator wires, carefully note wire routing. In particular, pay close attention to locations of cable straps that must be replaced. 2. See Figure 7-9 . Insert both voltage regulator connections and lock into place with lock tabs. 4. See Figure 7-6 . Release locks on wiring connectors and remove connectors from back of regulator. 3. Install any cable straps that may have been removed. 4.

Install radiator front cover and front cover fasteners. 5. Attach radiator side covers. See 1.6 RADIATOR SIDE COVERS . sm04782 6. See Figure 7-10 . Press rear brake master cylinder reser- voir back into its mounting slots in right side of radiator cover. 7. Replace main fuse. See 7.4 MAXI-FUSE . 8. See the VRSC electrical diagnostic manual and check voltage regulator for proper output. e Regulator Connector Figure 7-8. Voltage Regul 2009 VRSC ator Connector Service: Electrical 7-7