2009 — Installation

HOME INSTALLATION 1. Install relay in fuse block. 2. Slide cover over fuse blocks until latches fully engage tabs on blocks. Connect the cables to the correct battery terminals. Failure to do so could result in damage to the motorcycle electrical system. (00215a) 3. Slide fuse blocks onto frame mounting bracket. Tabs on bracket fit into slots on each side of fuse block cover. Do not over-tighten bolts on battery terminals. Use recommended torque values. Over-tightening battery ter- minal bolts could result in damage to battery terminals. (00216a) sm00920 Connect positive (+) battery cable first.

If positive (+) cable should contact ground with negative (-) cable connected, the resulting sparks can cause a battery explosion, which could result in death or serious injury. (00068a) 4. Connect negative battery cable. See 1.9 BATTERY MAINTENANCE . Figure 7-14. Starter Relay 5. Install air box cover by positioning the air box cover with the locating pins in the holes on the frame tabs. Turn bailhead fastener 1/4 turn clockwise. 6. Reinstall maxi-fuse and right side cover. 7-12 2009 VRSC Service: Electrical