2009 — Installation

HOME 7.8 STARTER REMOVAL NOTE Before removing the starter, perform diagnostics listed in the ELECTRICAL DIAGNOSTIC MANUAL. Connect positive (+) battery cable first. If positive (+) cable should contact ground with negative (-) cable connected, the resulting sparks can cause a battery explosion, which could result in death or serious injury. (00068a) 1. Remove right side cover. 2. Remove maxi-fuse. See 7.4 MAXI-FUSE . 3. Open seat. Connect the cables to the correct battery terminals. Failure to do so could result in damage to the motorcycle electrical system. (00215a) 4. Remove the air box cover. See 1.5 AIR CLEANER AND EXHAUST SYSTEM .

To prevent accidental vehicle start-up, which could cause death or serious injury, disconnect negative (-) battery cable before proceeding. (00048a) Do not over-tighten bolts on battery terminals. Use recommended torque values. Over-tightening battery ter- minal bolts could result in damage to battery terminals. (00216a) 5. Disconnect the negative battery cable. 6. Remove exhaust system to provide clearance for starter removal. See appropriate EXHAUST section for your model. 7. See Figure 7-14 . Pull back solenoid cable protective boot and loosen and remove hex-nut. Remove solenoid cable Be sure rubber boot covers starter solenoid terminal connected to positive (+) battery cable.

An uncovered terminal can short and cause sparks, which could result in a battery explosion and death or serious injury. (00463c) 1.9 BATTERY 1.5 AIR CLEANER AND . 1. Lubricate the starter o-ring with Harley-Davidson Special Purpose Grease, (Part No. 99857-97). 8. Reinstall maxi-fuse and the right side cover. See 7.4 MAXI- FUSE . 2. Install starter gear shaft into engine housing. NOTE Be sure starter gear shaft engages the teeth of the limiter assembly in the engine housing. sm00921 3. See Figure 7-15 . Install the two starter mounting bolts and washers (1). Alternately tighten the bolts to 17.6-27.1 Nm (13-20 ft-lbs). 1 2 4. Slide solenoid cable terminal ring (2) over starter post.

Thread on and tighten hex-nut to 6-10 Nm (53-88 in-lbs ). 5. Slide protective boot securely over terminal. 1. Starter mounting bolts and washers 2. Solenoid cable terminal ring Figure 7-15. Starter (protective boot removed) 2009 VRSC Service: Electrical 7-13 terminal ring (2). 8. Remove both starter mounting bolts and washers 9. Remove starter from right side of motorcycle. INSTALLATION 6. Connect negative (1). MAINTENANCE. 7. Install air box cov EXHAUST SYSTEM