HOME 7.9 STARTER SOLENOID GENERAL The starter solenoid is a switch that is designed to open and close the circuit to the electric starter motor. sm00922 1 REMOVAL 3 To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before pro- ceeding. (00251b) 2 NOTE The radiator fans are thermostatically controlled and will run will the ignition switch in the OFF position. However, pulling the maxi-fuse will disconnect power to the fans. To prevent damage to engine components, be sure the radiator has cooled before removing the maxi-fuse. 1. Positive battery cable 2. Starter cable hex-nut cover 3. Starter cable 1.
Remove left and right side covers and remove maxi fuse. See 7.4 MAXI-FUSE . Figure 7-16. Starter Solenoid 2. Open rider's seat. INSTALLATION 3. Remove the air box cover. See 1.5 AIR CLEANER AND EXHAUST SYSTEM . 1. See Figure 7-17 . Mate connector halves of paired black wire and green wire leads. in- 1.9 BATTERY MAINTENANCE . 5. Mate connector halves and tuck paired wire lead up under side cover. 5. See Figure 7-16 . Pull back starter cable hex-nut cover (2). Note cable locations and remove cable hex-nuts and cables. 6. Snap top of starter cable hex-nut cover onto solenoid. 6. Slide solenoid back and free from mounting tabs. 7.
Locate paired black wire and green wire lead directly in back of solenoid and press in release square and separate connector halves and remove solenoid. Connect the cables to the correct battery terminals. Failure to do so could result in damage to the motorcycle electrical system. (00215a) Do not over-tighten bolts on battery terminals. Use recommended torque values. Over-tightening battery ter- minal bolts could result in damage to battery terminals. (00216a) Connect positive (+) battery cable first. If positive (+) cable should contact ground with negative (-) cable connected, the resulting sparks can cause a battery explosion, which could result in death or serious injury. (00068a) 7.
Connect negative battery cable to battery. See 1.9 BAT- TERY MAINTENANCE . 7-14 2009 VRSC Service: Electrical 2. Slide solenoid into back of battery tray. cause 3. Install cables in loca attery 4. Thread on and torqu lbs). To prevent accidental vehicle start-up, which could death or serious injury, disconnect negative (-) b cable before proceeding. (00048a)