HOME 7.10 IGNITION/HEADLAMP KEY SWITCH GENERAL The ignition switch is non-repairable. If damaged, it must be replaced.The replacement ignition switch includes a fork lock, plunger and keys. The ignition switch and fork lock should be replaced at the same time so one key is used for both ignition and fork lock. sm00970 The automatic-on headlamp feature provides increased visibility of the rider to other motorists. Be sure headlamp is on at all times. Poor visibility of rider to other motorists can result in death or serious injury. (00030b) REPLACEMENT 1. Remove right side cover and remove maxi-fuse. See 7.4 MAXI-FUSE . 2. See Figure 7-18 .
Remove ignition switch protective cover by pressing in location shown by arrows using thumb and index fingers. Simultaneously lift up at bottom of protective switch cover with index finger of opposite hand and pull cover away from base of switch. Figure 7-19. Ignition Switch Fasteners 4. See Figure 7-20 . Carefully release latching tabs securing wiring harness connector to back of ignition switch. Pull connector out of ignition/light switch socket. Figure 7-18. Ignition Switch Cover showing back side) 3. See Figure 7-19 . Remove fasteners and remove ignition switch from frame. 5. Insert wiring harness connector into new ignition switch.
Gently push connector into socket until it locks into place. 6. See Figure 7-19 . Install ignition switch to frame. Secure with fasteners.Tighten fasteners to 4-7 Nm (35-62 in-lbs ). 7. Replace right side cover and maxi-fuse. 8. Test all functions of ignition switch. 7-16 2009 VRSC Service: Electrical sm00967 sm00971