HOME 7.12 HEADLAMP: VRSCDX GENERAL 3. Reach behind the headlamp bucket (6) and grasp the headlamp connector (8). The headlamp contains separate high and low-beam headlamp bulbs. Each bulb is a replaceable high output quartz halogen bulb type. 4. Squeeze the release latches on the connector and pull the connector away from the headlamp bulb. 5. While facing the headlamp from behind (looking toward the front of the motorcycle), twist the headlamp bulb approximately 45 degrees counterclockwise (CCW) and gently pull straight out of the headlamp. When replacement is required, use only the specified sealed beam unit or bulb, available from a Harley-Davidson dealer.
An improper wattage sealed beam or bulb, can cause charging system problems. (00209a) Installation 1. See Figure 7-22 . To install a new headlamp bulb, insert it into the hole in the rear of the headlamp. Facing the headlamp assembly from the rear (looking toward the front of the motorcycle): Never touch the quartz bulb. Fingerprints will etch the glass and decrease bulb life. Grab the bulb with paper or a clean, dry cloth. Failure to do so could result in bulb damage. (00210a) 2. Position the headlamp bulb with its connector housing pointing to approximately 4 o'clock. 3. Gently twist the bulb clockwise (CW) approximately 45 degrees, until it stops.
Handle bulb carefully and wear eye protection. Bulb con- tains gas under pressure, which, if not handled carefully, could cause serious eye injury. (00062b) NOTE Do NOT force the connector onto the headlamp bulb socket. The two headlamp connectors are not interchangeable. Forcing the wrong connector onto the bulb will damage the connector pins and/or bulb socket. in- screws in the headlamp bucket retainer for reassembly. 6. Move headlamp/nacelle assembly into place and snug fastener (10) and perform headlamp alignment. See 1.27 HEADLAMP ALIGNMENT . 1. See Figure 7-22 . Loosen M10 fastener (10) and allow headlamp/nacelle assembly to drop slightly forward. 2.
Remove fasteners (3), washers (4) and remove headlamp bucket retainer (5) from nacelle (23). 2009 VRSC Service: Electrical 7-19 4. Gently push the h headlamp bulb sock 5. Install headlamp bu n order fasteners (3). Tighte ounting lbs). Removal NOTE It is necessary to partially disassemble the headlamp i to replace headlamp bulbs. Note the positions of the m