HOME HEADLAMP BULB 1. See Figure 7-21 . To install a new headlamp bulb, insert it into the hole in the rear of the headlamp. Facing the headlamp assembly from the rear (looking toward the front of the motorcycle): Removal It is not necessary to disassemble the headlamp assembly in order to replace headlamp bulbs. NOTE a. Position the low beam bulb with its connector housing pointing to approximately 4 o'clock. b. Position the high beam bulb with its connector housing pointing to approximately 5 o'clock. 1. See Figure 7-21 . To replace the low beam or high beam headlamp bulb, reach behind the headlamp bucket and grasp the appropriate headlamp bulb socket connector. 2.
Gently twist the bulb clockwise (CW) approximately 45 degrees, until it stops. 2. Squeeze the release latches on the connector and pull the connector away from the headlamp bulb. NOTE Do NOT force the connector onto the headlamp bulb socket. The two headlamp connectors are not interchangeable. Forcing the wrong connector onto the bulb will damage the connector pins and/or bulb socket. 3. While facing the headlamp from behind (looking toward the front of the motorcycle), twist the headlamp bulb approximately 45 degrees counterclockwise (CCW) and gently pull straight out of the headlamp.
Installation NOTE The low beam headlamp bulb (labeled H11) mounts in the top hole in the rear of the headlamp assembly. The high beam bulb (labeled H9) mounts in the bottom hole. Be sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury. (00316a) 3. Gently push the headlamp wiring connector onto the headlamp bulb socket until it clicks into place. 7-18 2009 VRSC Service: Electrical