2009 — Installation

HOME 7.14 TAIL LAMP: VRSCF REMOVAL INSTALLATION NOTES 1. See Figure 7-25 . Install tail lamp assembly onto rear fender and tighten screws to 1.5-2 Nm (13-18 in-lbs ). • The VRSCF uses non-replaceable LED bulbs. The entire lamp assembly must be replaced if failure occurs. • Tail lamp cannot be removed with fender mounted to vehicle. 2. Install rear fender. See 2.41 REAR FENDER: VRSCF . 1. Remove rear fender assembly from vehicle. See 2.41 REAR FENDER: VRSCF . Be sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury. (00316a) 2. See Figure 7-25 .

Remove the four screws (1) securing the tail lamp (2) to the rear fender (3) and lift tail lamp assembly away from fender. 3. Turn ignition ON and test for proper tail lamp brake lamp and turn signal operation. Figure 7-25.Tail Lamp/Turn Signal Assembly: VRSCF 2009 VRSC Service: Electrical 7-23 sm06208a 2 3 1 1. Mounting screws (4) 2. Tail lamp/turn signal assembly 3. Rear fender