HOME 7.15 TURN SIGNALS AND RUNNING LIGHTS BULB REPLACEMENT 1. Locate notch on edge of front or rear turn signal lens cap. sm00991 2. Insert coin in notch. Carefully twist coin until lens pops out of turn signal housing. 3. Replace bulb. 1 2 a. Push bulb in and turn counterclockwise. b. Pull bulb from socket when tab on bulb clears opening on socket. c. Push new light bulb in and turn clockwise to lock in place. 3 4. Snap lens back into turn signal housing with the notch facing down. NOTE 1. Front Turn Signal Connector [31] 2. Right handlebar controls connector [22] 3.
Left handlebar controls connector [24] If after replacing a bulb, the turn signal or running lamp will not light, check the wiring, the ground at the socket and/or the switch. Figure 7-26. Front Turn Signal and Handlebar Control Switch Connectors (typical) LAMP REPLACEMENT General 1. 7.4 MAXI-FUSE . 2. Change turn signal. 3. Front Turn Signals which must be replaced if removed. 1. Remove left side cover. 2. See Figure 7-26 [31B] from socket [31A]. 3. 4. in routing hole. 5. See Figure 7-28 to remove turn signal. 6. cover and remove main fuse. See ver and replace main fuse. s NOTE nal wires, carefully note routing. In tion to the locations of cable straps removed. er.
eparate front turn signal connector A]. n signal wires in connector. Remove ignal wire terminals from connector. gnostic manual for more information. nd end of turn signal wire and pull in upper fork clamp. Leave wire lead d retainer and loosen ball stud clamp l. through the handlebar cable clips ntrols wire sheath. sm00993 Figure 7-27. Front Turn Signal C 7. Lay old turn signal assembly ne wires to length. Trim sheath bac (2.5 in) from ends of wires. See gnostic manual for more inform e: Electrical onnector [31] (typical) xt to new one and cut new k approximately 63.5 mm the VRSC electrical dia- ation.