HOME 8. Install new turn signal lamp housing and route wire har- ness through handlebar cable clips. sm01082 9. Wrap wire lead around turn signal wires and pull through routing hole in fork clamp. 5 10. Crimp new pin terminals onto wires. 4 11. Insert terminals into turn signal connector and mate con- nector [31B] to socket [31A]. 3 12. Install left side cover. Rear Turn Signals NOTE 1 2 Before removing turn signal wires, carefully note routing and location of each wire terminal in connector. 1. See 7.13 TAIL LAMP: ALL EXCEPT VRSCF . Remove tail lamp housing assembly from rear fender. Locate appro- priate rear turn signal harness and connector inside tail lamp housing recess in rear fender.
2. See Figure 7-29 . Drawing shows rear lighting module assembly removed from rear fender for clarity. Note loca- tions of turn signal wires in connector. Remove turn signal wire terminals from connector. See the VRSC electrical diagnostic manual for more information. 1. Turn signal 2. Jam nut 3. Ball stud 4. Ball stud clamp 5. Retainer and washer 3. Remove fasteners and support plate. Remove turn signal housing from vehicle. Carefully pull turn signal wiring har- Figure 7-28. Front Turn Signal Mounting 4. 5. 6. Install new turn signal housing and support plate, routing wiring harness back through holes in fender. Bring wire ends into tail lamp housing recess in rear fender.
sm01083 Insert terminals into turn signal connector and mate con- 1 nector to socket. NOTE ure to install turn signals on correct sides of motorcycle n-sized drain hole is on the bottom to allow proper draining y water from condensation that may accumulate. 4 Install tail lamp housing assembly into rear fender. See 7.13 TAIL LAMP: ALL EXCEPT VRSCF. 3 2 1. Turn signal assembly (2) 2. Turn signal connector (2) 3. Fastener (4) 4. Support plate (2) Figure 7-29. Rear Turn Signal Mounting (typical) 2009 VRSC Service: Electrical 7-25 4. Support plate (2) Figure 7-29. Rear Turn Si 2009 VR gnal Mounting (typical) SC Service: Electrical 7-25