HOME 7.16 TURN SIGNALS: VRSCF TURN SIGNAL REPLACEMENT Front Turn Signals SM06271 NOTE 1 The turn signals are integrated into the mirror stems and are non-repairable LED lights. If a front turn signal fails, replace the mirror with the turn signal. 2 1. Remove right side cover and remove main fuse. See 7.4 MAXI-FUSE . NOTE Before removing turn signal wires, carefully note routing. In particular, pay close attention to the locations of cable straps which must be replaced if removed. 2. Remove left side cover. 3 3. See Figure 7-31 . Separate front turn signal connector [31B] from socket [31A]. 3 4. Note locations of turn signal wires in connector.
Remove corresponding turn signal wire terminals from connector. See the electrical diagnostic manual for more information. 4 4 5. Separate clutch side and throttle and brake side switch housings. See 2.22 HAND GRIPS . 6. Wrap wire lead around end of turn signal wire and pull through routing hole in upper fork clamp. Leave wire lead in routing hole. 1. Turn signal assembly, left 2. Turn signal assembly, right 3. Lockwasher (2) 4. Nut 7. See Figure 7-31 . Hold mirror stem and loosen nut (4) on turn signal stud. Do not remove turn signal. Figure 7-31. Front Turn Signals: VRSCF 8. Pull turn signal wire through the handlebar around handlebar controls and wire sheath. 9. See Figure 7-31 .
Remove lockwashers (3) and remove turn signal. one and cut new in-lbs. ) sm06275 10. Lay old turn signal assembly next to new wires to length. Trim sheath back appro 4 (2.5 in) from ends of wires. See the ele 3 manual for more information. 11. Install new turn signal assembly and tig Nm (65-75 in-lbs). 12. Adjust mirrors on turn signal assem fastener on back of mirror to 4.5-5.7 Nm 1 13. Wrap wire lead around turn signal wire harness around handlebar controls 2 through handlebar and pull through ro clamp. 1. Front turn signal connector 14. Crimp new pin terminals onto wires. 2. Left handlebar controls connector 15. Insert terminals into turn signal connect 3.
Right handlebar controls connector nector [31B] to socket [31A]. 4. Turn signal module 16. Install left side cover. Figure 7-30. Front Turn Signal and Handlebar Control Switch Connectors: VRSCF 2009 VRSC Service: nector [31B] to socket [31A]. le 16. Install left side cover. Signal and Handlebar Control nnectors: VRSCF 2009 VRSC Figure 7-30. Front Turn Switch Co