2009 — Turn Signal Replacement

HOME Rear Turn Signals tions of wires in the different connectors. Remove wire terminals from connectors. See the electrical diagnostic manual for more information. • The VRSCF uses non-replaceable LED bulbs. The entire tail lamp/turn signal assembly must be replaced if failure occurs. NOTES 4. Install new tail lamp/turn signal assembly in fender. 5. Install rear fender. See 2.41 REAR FENDER: VRSCF . • Tail lamp/turn signal assembly cannot be removed with fender mounted to vehicle. 6. Insert terminals into connectors and mate connectors to sockets. 1. Remove rear fender. See 2.41 REAR FENDER: VRSCF . 2. Remove tail lamp/turn signal assembly from rear fender. See 7.14 TAIL LAMP: VRSCF .

Be sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury. (00316a) 3. See Figure 2-170 . Drawing shows tail lamp/turn signal assembly removed from rear fender for clarity. Note loca- 7-28 2009 VRSC Service: Electrical