2009 — Installation

HOME 7.17 TURN SIGNAL SECURITY MODULE (TSSM) GENERAL The Turn Signal Security Module (TSSM) is located beneath the passenger seat, mounted in an electrical caddy on the rear fender. sm01095 REMOVAL 1 1. Verify security lamp is not blinking (vehicle is disarmed). 2. Remove right side cover and remove main fuse. See 7.4 MAXI-FUSE . 2 3 3. Open seat. 4. See Figure 7-32 . Remove fastener and washer. Slide passenger seat forward slightly to detach it from the mounting tab on the rear of the fender. Then slide seat back and out from underneath seat strap. Remove pas- senger seat from motorcycle. 1. Passenger seat 2. Fastener 3. Washer 5. See Figure 7-33 .

Squeeze wiring harness connector release latches and carefully pull wiring harness connector out of connector socket on TSSM. Figure 7-32. Passenger Seat Attachment 6. Lift up TSSM and slide it out of mounting bracket. Figure 7-33.Turn Signal Security Module Mounting Be sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury. (00316a) 2009 VRSC Service: Electrical 7-29 1. Slide new TSSM into mounting bracket. Make sure TSSM slides all the way forward in the bracket. 2. Carefully insert wiring harness connector into TSSM socket. Push connector all the way in until release latches lock in place.

NOTE The wiring harness connector is keyed and can only be inserted fully in the TSSM socket one way. DO NOT force the connector into the socket. Doing so can damage the connector and/or socket. 3. See Figure 7-32. Slide passenger seat under seat strap and engage mounting tab on the fender into slot in bottom rear of seat. Make sure TSSM wiring harness is not pinched under seat frame. 4. Attach passenger seat to motorcycle with fastener and washer. Tighten to 11-17 Nm (97-150 in-lbs). 5. Turn ignition switch to the FUEL position and close seat. Then turn ignition switch to the LOCK position. 6. Replace maxi-fuse and right side cover. sm01096 3 2 1 4 1. TSSM 2. Wiring harness connector 3.

Connector release latch (2) 4. TSSM mounting caddy