HOME 7.19 ALTERNATOR GENERAL The alternator is located behind the alternator cover, on the left side of the engine. The alternator consists of permanent magnets mounted around the circumference of a rotor and a series of radial wire coils statically mounted in a stator assembly. When rotated by the engine, the rotor magnets induce a voltage in the wire coils of the stator alternately reversing polls. sm04832 The rotor of the alternator is bolted to the crankshaft.
On the crankshaft side of the rotor is a ball clutch mechanism that works in combination with the starter limiter gear to enable the starter ring gear and the rotor/crankshaft to rotate independently of each other.The circumference of the rotor is machined with teeth that identify a reference point for the crank position sensor (CKP). The stator is bolted to the inside of the alternator cover and delivers induced voltage to a voltage regulator through a wire harness that passes through a boss in the side of the alternator cover. Figure 7-36. Voltage Regulator Connector Lock Clip 6. Remove two fasteners securing derby cover. Remove cover. The alternator cover is secured with 14 fasteners.
The derby cover is located on the alternator cover, secured with two fasteners. 7. Place drip pan underneath alternator cover to catch any residual oil that may drain out when cover is removed. NOTE 8. Remove alternator cover fasteners in reverse order of torque sequence. See 7.19 ALTERNATOR, Installation . 9. Install two GASKET ALIGNMENT DOWELS (Part No. HD- 45340) in two of the alternator cover holes to steady cover as it is removed. The high-output rotor contains powerful magnets. Exercise caution to prevent possible hand injury during removal and installation. (00558b) 10. See Figure 7-37 .
Using two inspection cover fasteners (3), position ALTERNATOR STATOR COVER REMOVER/INSTALLER TOOL (Part No. HD-45304) (4) as shown. REMOVAL TOOL NAME PART NUMBER 11. Remove the alternator cover. 12. Inspect rotor for wear or damage.The rotor and ball clutch assembly for the starter ring gear are replaced as one assembly. ALTERNATOR STATOR COVER REMOVER/INSTALLER TOOL HD-45304 CRANKSHAFT ROTATING WRENCH HD-45314 13. Holding 36 mm rotor nut with CRANKSHAFT ROTATING ALTERNATOR ROTOR REMOVER HD-45315 WRENCH (Part No. HD-45314), loosen rotor fastener. Air impact tool may be used for REMOVAL ONLY. GASKET ALIGNMENT DOWELS HD-45340 14. Install ALTERNATOR ROTOR REMOVER (Part No. HD- 1.
Remove right side cover and maxi-fuse. See 7.4 MAXI- FUSE . 45315) and hand tighten. 2. Remove fastener securing bottom of left radiator trim cover. Remove trim cover. 15. See Figure 7-38 . Use an impact socket and wrench to tighten the tool removing the rotor from the crankshaft taper. 3. See Figure 7-36 . Push straight down to remove stator to regulator connector [46] from metal clip on side of radiator cover. 16. To install a rotor assembly, use the following procedure: a. Install rotor shell and tighten rotor nut to 83 Nm (60 4. connector [46B] half. 5. ator wiring harness. For diagnostic information, see the VRSC ELECTRICA GNOSTIC MANUAL. ft-lbs).
ector half [46A] from voltage regulator b. Loosen one full turn. c. Tighten to 180 Nm (132 ft-l top of jiffy stand and remove altern- 2009 VRSC 132 ft-l bs Se