2009 — Disassembly

HOME 2 sm00973 6. See Figure 7-40 . While pushing on rib (4) from outside of crankcase, draw grommet (1) through bore by pulling on T-stop (2). Rock grommet back and forth to facilitate removal. Exercise caution to avoid damaging rib on grommet if stator is to be reused. 3 7. Draw stator wire harness (5) and socket terminals through crankcase bore. For best results, feed one wire and socket terminal at a time. 4 8. Remove stator and wire harness from alternator cover. Figure 7-38. Alternator Rotor Remover (HD-45315) Figure 7-39. Removing Stator From Alternator Cover DISASSEMBLY 1. Remove three wire leads from connector [46A] (6).

Insert a pick (Snap-on TT600-3) into square under locking tang and pivot end of pick toward terminal to depress the locking tang. Gently pull on wire to pull terminal from wire end of connector (6). 2. See Figure 7-39 . Remove fastener (4) and wire harness clip (5) from alternator cover (1). 3. Remove stator mounting fasteners (3) and captive washers from stator (2). Remove three stator mounting fasteners (3) and pull stator straight up out of alternator cover (1). Note orientation of slot in cover stator hub and clip on stator. 4. Using point of awl, carefully press rib on grommet (7) away from crankcase and then insert awl into bore between grommet and casting. 5.

Tilt awl slightly squirting isopropyl alcohol or glass cleaner into opening. Repeat this step at one or two other locations around grommet. 7-32 2009 VRSC Service: Electrical 1 sm04800 1. Alternator cover 2. Gasket alignment dowel (2) 2 3. Derby cover fasteners 4. Alternator cover remover/installer tool (HD- 1 45304) Figure 7-37. Removing Alternator Cover sm00974 4 3 1. Alternato 2. Stator 3. Stator mo 4. Fastener 5. Harness c 6. Harness c 7. Grommet 8. Boss 6 8 7 5 r cover unting fasteners (3) lip onnector