2009 — Installation

HOME sm00978 INSTALLATION TOOL NAME PART NUMBER ALTERNATOR STATOR COVER REMOVER/INSTALLER TOOL HD-45304 GASKET ALIGNMENT DOWELS HD-45340 2 1 1. See Figure 7-37 . Make sure ALTERNATOR STATOR COVER REMOVER/INSTALLER TOOL (Part No. HD- 45304) (4) is installed as shown. Secure to alternator cover with two derby cover fasteners. Turn handle of tool clock- wise (CW) several turns. 5 3 2. Make sure two GASKET ALIGNMENT DOWELS (Part No. HD-45340) (2) are installed in case. 4 3. Slide new alternator cover gasket onto alignment dowels and press flush against engine case. 1. Grommet 2. T-stop 3. Boss 4. Rib 5. Wire harness 4.

Slide alternator cover onto alignment dowels.Turn handle of remover/installer counterclockwise (CCW) until it turns freely. Remove two derby cover fasteners and remover/installer tool. Figure 7-40. Stator Wiring Harness Grommet NOTE To avoid oil leaks caused by warping of alternator cover, in next step, tighten fasteners in alternating pattern back and forth across face of cover. See Figure 7-41 . ASSEMBLY 1. gasket sealing surfaces. 2. See Figure 7-40 time. 3. residue. 4. 5. See Figure 7-39 in alternator cover (1). 6. tighten to 8.2-10.7 Nm (72-95 7. (72-95 in-lbs ). 8. Push wire socket terminals into connector [46A]. Figure 7-41. Alternator Cover Torque Sequence in-lbs ).

nator cover and gasket sealing Remove all sealing material from . nside cover, feed socket terminals (5) through boss (3) on cover wall. ne wire and socket terminal at a with isopropyl alcohol or glass be clean and free of dirt and oily grommet (1). Push grommet (1) e carefully pulling on outside wire is complete when T-stop (2) con- ) exits crankcase bore. tator (2) oriented to cover (1) so alternator cover at approximately astener holes in stator with holes ting fasteners (3) and alternately 72-95 in-lbs). over wire harness into alternator ener (4). Tighten to 8.2-10.7 Nm sm00981 10 12 14 8 1 3 6 5 4 2 7 13 9 11 5. See Figure 7-41. Secure altern with 14 fasteners. Tighten to 9.7 6.

Clean derby cover. Inspect O-rin if damaged. 2009 VRSC ator 9.7 Nm g on Serv