2009 — Installation

HOME 7. Install derby cover on alternator cover with two fasteners. Tighten to 8.2-10.7 Nm (72-95 in-lbs ). 9. Plug stator connector into three-wire voltage regulator connector. Secure connector to left side of radiator cover with connector clip. 8. Route stator wiring harness through cable clip on top of jiffy stand. Latch cable clip. 10. Install radiator trim cover onto radiator cover. Make sure no wires become pinched under cover. Secure with fastener. Tighten to 3-4 Nm (26-35 in-lbs ). 7-34 2009 VRSC Service: Electrical