HOME 7.20 INSTRUMENT CLUSTER: VRSCAW GENERAL The instrument cluster contains the speedometer, tachometer, fuel gauge and indicator lamps. It is a sealed unit. If any of the instruments or indicator lamps becomes defective, the entire instrument cluster must be replaced. sm01097 1 3 5 2 REMOVAL 1. Remove right side cover and maxi-fuse. See 7.4 MAXI- FUSE . 4 9 2. See Figure 7-42 .To free lower end of top handlebar cover, loosen two mounting fasteners holding headlamp bracket to upper triple clamp. 6 3. Without removing cover, remove two fasteners (6) securing handlebar top cover (2) and instrument housing bezel (1) to handlebar bottom cover (5). NOTE See Figure 7-43 .
Bezel hook holds bottom of bezel and top cover to lower handlebar cover and can be damaged if forced during removal or installation. 7 8 4. From headlamp bracket end of cover, gently tilt top handlebar cover and instrument bezel up and back to remove cover and bezel. 1. Instrument housing bezel 2. Handlebar top cover 3. Instrument cluster 4. Handlebars 5. Handlebar bottom cover 6. Fastener (2) 7. Upper triple clamp 8. Headlamp and headlamp bracket 9. Fastener (2) NOTE Bezel can remain snapped to upper handlebar cover. 5. See Figure 7-44 . Squeeze two release latches together and gently pull wiring harness connector [39] from instru- ment cluster socket. Figure 7-42.
Instrument Cluster Removal 6. Remove instrument cluster from handlebar bottom cover. sm01011 Figure 7-43. Bezel Hook 2009 VRSC Service: Electrical 7-35