2009 — Installation

HOME sm01012 1 2 3 3. See Figure 7-42 . Orient instrument housing bezel and handlebar top cover, and fit bezel hook over tab on handlebar bottom cover. Gently press handlebar top cover and instrument housing bezel down until bezel hook snaps onto tab. 4. Fit bottom end of handlebar top cover behind headlamp mounting bracket. Bezel edge should fit snugly to grooved rim of lower and upper cover. 4 1. Instrument cluster 2. Instrument cluster socket 3. Wiring harness connector [39] 4. Release latch (2) 5. Secure handlebar covers with two fasteners. Tighten fasteners to 1.3-1.9 Nm (12-16 in-lbs ). 6. Tighten headlamp bracket fasteners to 11-18 Nm (8-13 ft-lbs). Figure 7-44.

Instrument Cluster Harness Connector [39] 7. Replace maxi-fuse and right side cover. 8. Verify that instrument cluster is operational: INSTALLATION a. Turn ignition/seat release switch to the ACC position. Instrument background lighting will illuminate, gauge needles will sweep their full range of motion and the battery, security, coolant temperature and check engine indicator lamps will illuminate. 1. Set new instrument cluster into handlebar bottom cover. 2. See Figure 7-44 . Install wiring harness connector into instrument cluster socket. Gently push connector into socket until release latches lock into place. b. Turn ignition/seat release switch to the LOCK position.

NOTE See Figure 7-43 . Bezel hook holds bottom of bezel and top cover to lower handlebar cover and can be damaged if forced during removal or installation. 7-36 2009 VRSC Service: Electrical