HOME 7.21 INSTRUMENT CLUSTER: VRSCDX GENERAL INSTALLATION The instrument cluster contains the speedometer, tachometer, fuel gauge and indicator lamps. It is a sealed unit. If any of the instruments or indicator lamps becomes defective, the entire instrument cluster must be replaced. 1. See Figure 7-45 . Assemble bezel, instrument cluster and housing. Install and tighten fasteners to 1.3-1.9 Nm (12-16 in-lbs ). 2. Fit hinge of housing to peg on handlebar clamp. Install and tighten fastener to 2.2-2.8 Nm (20-24 in-lbs ). REMOVAL 1. Remove right side cover and maxi-fuse. See 7.4 MAXI- FUSE . 3. Squeeze two release latches together and mate connector [39B] to instrument cluster. 2.
See Figure 7-45 . Remove fastener at top of instrument housing. 4. Close housing. Install and tighten top housing fastener to 2.2-2.8 Nm (20-24 in-lbs ). 3. Holding instrument housing to prevent damage to air box cover, rotate housing open. 5. Replace maxi-fuse and right side cover. 6. Verify that instrument cluster is operational: 4. See Figure 7-46 . Squeeze two release latches together and pull wiring harness connector [39B] from instrument cluster. a. Turn ignition/seat release switch to the ACC position.
Instrument background lighting will illuminate, gauge needles will sweep their full range of motion and the battery, security, coolant temperature and check engine indicator lamps will illuminate. 5. See Figure 7-45 . Loosen and remove hinge fastener and slide housing off of hinge peg. 6. Remove four fasteners and separate housing, instrument cluster and bezel. b. Turn ignition/seat release switch to the LOCK position. Figure 7-45. Instrument Cluster (typical) 2009 VRSC Service: Electrical 7-37 sm01014 Figure 7-46. Instrument Cluster Connector [39B] sm01098 2 3 4 5 1 6 1. Instrument cluster 2. Bezel 3. Instrument housing 4. Fastener 5. Hinge fastener 6. Top housing fastener