2009 — Installation

HOME 7.22 INSTRUMENT CLUSTER: VRSCF REMOVAL 1. Remove right side cover and main fuse. See 7.4 MAXI- FUSE . sm06180a 1 2. Remove headlamp. See 7.11 HEADLAMP: VRSCAW/VRSCF . 3. See Figure 7-47 . Squeeze two release latches together and gently pull wiring harness connector [39] from instru- ment cluster socket. 2 5 3 sm01012 1 2 3 4 6 4 1. Instrument cluster 2. Instrument cluster socket 3. Wiring harness connector [39] 4. Release latch (2) 7 1. Screw, instrument cluster bezel (4) 2. Bezel, instrument cluster 3. Instrument cluster 4. Reset switch boot 5. Screw, instrument cluster housing to handlebars (2) 6. Instrument cluster housing 7. Handlebars Figure 7-47.

Instrument Cluster Harness Connector [39] (Typical) Figure 7-48. Instrument Cluster: VRSCF 4. See Figure 7-48 . Remove the four screws (1) securing the bezel (2) to the instrument cluster housing (6) and remove bezel. 5. Remove reset switch boot (4) and remove instrument cluster (3) from housing (6). INSTALLATION 1. Install instrument cluster (3) into housing (6) and install reset switch boot (4). 2. Orient instrument cluster bezel (2) and install the four screws (1) that secure the bezel to the instrument cluster housing (6). 3. Install wiring harness connector into instrument cluster socket. Gently push connector into socket until release latches lock into place. 4.

Install headlight assembly and tighten headlamp bracket fasteners to 11-18 Nm (8-13 ft-lbs). 5. Replace maxi-fuse and right side cover. 7-38 2009 VRSC Service: Electrical