HOME 7.23 VEHICLE SPEED SENSOR (VSS) GENERAL 2. Install maxi-fuse and side cover. The vehicle speed sensor (VSS) is a hall effect sensor that takes readings off a drive gear in the transmission. sm01019 The VSS is located behind the rear cylinder on the back of the engine case, below the cam chain tension adjuster. 2 REMOVAL 1. Remove right side cover and maxi-fuse. 1 2. See Figure 7-49 . Disconnect VSS wiring harness cable connector [65B] from the VSS. 3. Remove the fastener securing the VSS. Carefully pull the VSS and o-ring straight out of the transmission case. INSTALLATION The new VSS o-ring has a blue teflon coating that provides lubrication during installation.
It is not necessary to coat the o- ring with engine oil to install it. NOTE 1. Vehicle speed sensor 2. Fastener Figure 7-49. Vehicle Speed Sensor (typical) 1. See Figure 7-49 . Install new VSS with o-ring, and fastener (2). Tighten to 8.2-10.7 Nm (73-95 in-lbs ). 7-40 2009 VRSC Service: Electrical