HOME 7.24 NEUTRAL SWITCH GENERAL 6. If any oil escaped while neutral switch was removed from vehicle, check the engine oil level. See 1.8 ENGINE OIL AND FILTER . Replenish engine oil as necessary. The neutral switch is located on the bottom of the engine case near the rear of the engine.The two-terminal switch is normally closed. When the transmission is in neutral and the ignition switch is in the IGN position, the neutral switch causes the NEUTRAL indicator lamp to illuminate. sm01020 REMOVAL 1. Remove right side cover and maxi-fuse. See 7.4 MAXI- FUSE . 2. Make sure transmission is shifted into NEUTRAL. 3. Place a clean container under motorcycle to catch any oil that may escape. 1 4.
See Figure 7-50 . Remove two wiring harness connectors (2) from neutral switch (1). Gently pull connectors straight off switch studs. 2 5. Using a 7/8 in. box wrench, remove neutral switch and o- ring from engine case. 1. Neutral switch 2. Wiring harness connectors (2) INSTALLATION Figure 7-50. Neutral Switch Location (typical) NOTE The transmission shifter must be in the NEUTRAL position the shifter cam ramp. 1. See Figure 7-51 2. may be attached to either stud. 3. See Figure 7-50 4. 5. a. b. Verify that transmission shifter is in NEUTRAL. c. Check to see that NEUTRAL indicator lamp illumin- ates. Figure 7-51. Neutral Switch (typical) d. Turn off ignition switch. 2009 VRSC Service:
Electrical 7-41 itch to allow the switch ball to engage Lubricate new o-ring (2) with engine oil. ch with o-ring into engine case.Tighten 113-146 in-lbs). NOTE not polarity sensitive. Either connector her stud. nstall wiring harness connectors (2) onto witch (1). Gently push connectors until n studs. e and right side cover. h for proper operation. switch to IGN position. sm01136 1 2 3 1. Ball 2. O-ring 3. Switch stud