HOME 7.25 OIL PRESSURE SWITCH GENERAL 8. Using OIL PRESSURE SWITCH SOCKET (Part No. HD- 45300), remove the oil pressure switch. The oil pressure switch monitors oil pressure in the crankcase. If the oil pressure drops below 13.8-34.5 kPa (2-5 psi), the oil pressure switch is tripped and illuminates the low oil pressure indicator light. The oil pressure switch is located in the valley on top of the engine crankcase between the cylinders. sm01021 REMOVAL TOOL NAME PART NUMBER OIL PRESSURE SWITCH SOCKET HD-45300 1. Open seat. 2. Remove air box cover. See 1.5 AIR CLEANER AND EXHAUST SYSTEM . Figure 7-52.
Oil Pressure Switch (typical) Cover the throttle body bores with duct tape to prevent objects from falling down the injector bores. Do NOT use shop cloths or objects that could damage the throttle plates. (00212d) INSTALLATION TOOL NAME PART NUMBER OIL PRESSURE SWITCH SOCKET HD-45300 NOTE To prevent accidental vehicle start-up, which could cause death or serious injury, disconnect negative (-) battery cable before proceeding. (00048a) Perform step 1 below only if original oil pressure switch is being re-installed. New switches have a sealant contact patch on the threads. If new switch is being installed, begin with step 2. 3. Disconnect negative battery cable. 1.
Coat threads of oil pressure switch with LOCTITE High Performance Pipe Sealant with Teflon (LOCTITE Part No. PST565). 4. Remove horn assembly. 5. Remove MAP sensor. 2. Using OIL PRESSURE SWITCH SOCKET (Part No. HD- 45300), install oil pressure switch. Tighten to 10.8-13.6 Nm (96-120 in-lbs ). 6. Remove the idle air control (IAC) motor wiring harness connector [87B] and throttle position sensor (TPS) con- nector [88B] from the fuel injector assembly. Tuck the wiring harnesses back out of the way. 3. Attach wiring connector to oil pressure switch. 7. See Figure 7-52 . Remove the wiring harness connector from the oil pressure switch. 4.
Attach IAC motor and TPS sensor wiring harness con- nectors [87B] and [88B]. 5. Install MAP sensor. NOTES • The engine in the figure has been stripped to clarify the location of the oil pressure switch. 6. Install horn assembly. 7. Connect negative battery cable. Tighten bolt to 6.8-10.8 Nm (60-96 in-lbs ). • It will be necessary to use a universal adapter and exten- sion with the oil pressure switch socket in the next step to fully seat the socket on the oil pressure switch. In place of a universal adapter and standard extension, a Snap-on Wobble Extension, such as the FXW8 or FXW11A may be used. 8. Remove duct tape from injector intakes. 9. Replace air box cover.
See 1.5 AIR CLEANER AND EXHAUST SYSTEM . 10. Turn ignition switch to the FUEL position and close seat. Then turn ignition switch to the LOCK position. • When removing the oil pressure switch, take care to avoid damaging wiring connectors and sensor bodies located nearby. 11. Test oil pressure switch for proper operation. 7-42 2009 VRSC Service: Electrical