HOME 7.26 REAR STOPLIGHT SWITCH GENERAL The stoplight switch monitors brake fluid pressure in the rear brake line. When the vehicle operator steps on the rear brake pedal and pressure in the brake line reaches a preset level, the stoplight switch is tripped and illuminates the stop light. The stoplight switch is located on the rear brake line T-fitting. When closing the seat, make sure the ignition switch is in the FUEL position. If the ignition switch is in any other position when the seat is closed, the seat latch mechanism could be damaged. (00196a) REMOVAL 1. Remove right side cover and maxi-fuse. See 7.4 MAXI- FUSE . After repairing the brake system, test brakes at low speed.
If brakes are not operating properly, testing at high speeds can cause loss of control, which could result in death or serious injury. (00289a) 2. Open seat. 3. Remove exhaust mufflers and collector. See appropriate exhaust system removal for your model. 6. Bleed brake system. See 1.12 BLEEDING BRAKES . 4. See Figure 7-53 . Remove two wiring harness terminal connectors (1) from stoplight switch (2). 5. Place a clean container under stoplight switch and brake line to catch escaping fluid. Be sure headlamp, tail and stop lamp and turn signals are operating properly before riding. Poor visibility of rider to other motorists can result in death or serious injury. (00478b) 6.
Using a 1-inch open end wrench, remove stoplight switch from T-fitting (3). INSTALLATION 7. Replace main fuse and right side cover. 8. Check tail lamp/stop lamp for proper operation. NOTE 2. 1. PST565). 2. switch with a 1-inch open end wrench. 3. lamp switch. 4. exhaust system removal for your model. 5. Close seat. Figure 7-53. Stop Light Switch (NON-ABS forward-mount controls shown) 2009 VRSC Service: Electrical 7-43 rear stop lamp switch is a sealant contact patch installed, begin with step tch with LOCTITE High eflon (LOCTITE Part No. ke line T-fitting. Tighten rench. inal connectors to stop ufflers. See appropriate model. witch is t patch th step E High sm01022 2 1 3 1.
Wiring harness terminal connector (2) 2. Stop light switch 3. Rear brake line T-fitting