HOME 7.27 HORN INSPECTION using mount (10), harness mount bracket (13) and acorn nut (3). Tighten to 9-15 Nm (80-132 in-lbs ). Figure 7-54. Horn (typical) NOTE When tightening the acorn nut in the next step, make certain the horn cover does not come in contact with the fins on the cylinder heads. If it does, loosen the acorn nut, reposition the horn assembly and retighten the nut. 7-44 2009 VRSC Service: Electrical The horn is located on the left side of the motorcycle, mounted under the top frame rail, between the engine cylinder heads. If the horn fails to sound or does not sound satisfactorily, check for loose, frayed or damaged horn terminal wires, discharged battery or corroded ground.
The horn is permanently sealed and non-repairable. If defective, it must be replaced. NOTE No tonal adjustments can be made to this horn. REPLACEMENT 1. See Figure 7-54. Remove acorn nut (3), harness mount bracket (13) and detach horn assembly from motorcycle. 2. Note location, and remove wires from connections on back side of horn (9). 3. Remove nut (6) securing horn to mounting bracket (11). NOTES • When tightening the nut in the next step, make certain the horn does not come in contact with the horn cover. If it does, loosen the flange nut, reposition the horn, and retighten the nut.
• Over-tightening the nut (6) can cause permanent horn damage resulting in reduced volume and tone quality. 4. Install new horn on bracket (11). Secure with nut (6). Tighten to 6-8 Nm (53-70 in-lbs). 5. See Figure 7-55. Attach wiring. a. Connect BK ground wire to silver post. b. Connect Y/BK horn power wire to copper post. NOTE Improperly installed horn can strike fins on the cylinder heads during operation. The interference can cause substantial cos- metic damage. 6. See Figure 7-54. Attach horn assembly to motorcycle sm06446 13 10 3 6 11 7 9 8 2 5 1 4 12 1. Screw 2. Screw (2) 3. Acorn nut 4. Washer 5. Locknut 6. Nut 7. Nut (2) 8. Horn cover 9. Horn 10. Mount 11. Bracket 12. Ground wire 13.
Harness mount bracket