HOME 7.28 COOLING FANS GENERAL The two cooling fans are mounted one above the other in a single assembly behind the radiator. The cooling fans are controlled electronically and are turned on and off as necessary to maintain an acceptable coolant temperature range. sm04793 3 2 Cooling fans operate automatically, even when the ignition switch is off. Keep hands away from fan blades. Contact with a rotating fan blade can result in minor or moderate injury. (00093a) 1 REMOVAL 1. Remove right side cover and maxi-fuse. See 7.4 MAXI- FUSE . 1. Stator-to regulator connector 2. Top & bottom fan power connectors 3. Crank position sensor connector 2. Remove fastener and right radiator trim cover. 3.
Pull rear brake master cylinder reservoir straight away from its mounting slots in right side of radiator cover. Figure 7-56. Left Side Wiring Connectors (typical) 4. Remove fastener and left radiator trim cover. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. NOTE sm01101a re removing wiring harnesses, carefully note wire routing. articular, pay close attention to locations of cable straps must be replaced. See Figure 7-56. Clip cable wrap used to secure cooling fan wire harness to crankshaft position sensor (CKP) harness. Push connectors and wire harnesses away from coolant drain plug up and behind shift lever. Place a container under left side of radiator. See 5.3 ENGINE COOLANT.
6 Loosen but do not remove coolant drain plug. Turn drain plug until slot in threads drains into container. Open seat and remove pressure cap to accelerate coolant drain from radiator. Hand tighten coolant drain plug. Place a container under engine, remove oil filler plug/dip- stick, and oil drain plug and drain oil. Reinstall dipstick and drain plug. See 1.8 ENGINE OIL AND FILTER. Separate top and bottom cooling fan connectors (2). Separate crank position sensor connector (3). 1. Frame radiator mou 2. Fan fasteners Cover front fender with shop towel or protective cover. 3. Cooling fan assemb Remove fasteners and washers on each side of radiator 4. Radiator cover.
Remove radiator cover with chrome inlet bezels 5. Fasteners attached. 6. Cross member grom Remove the radiator and oil cooler assembly. See Figure 7-57. Radia 5.8 RADIATOR AND OIL COOLER. Separate oil line quick connect fittings. See 5.7 OIL LINE DISASSEMBLY FITTINGS. 1. See Figure 7-58. Remo (1) on fan assembly. 2009 VRSC Service: Electrical 1 2 3 4 5 6. Cross member grom or and oil cooler assembly. See Figure 7-57. Radia OIL COOLER. ck connect fittings. See 5.7 OIL LINE DISASSEMBLY 1. See Figure 7-58. Remo (1) on fan assembly. e: Electrical tor Mounting (typical) Separate oil line qui FITTINGS. 2009 VRSC Servic ve two lower mounting fasteners