2009 — Repair Procedures

HOME 7.29 HANDLEBAR SWITCH ASSEMBLIES GENERAL The switches are of rugged construction and feature a superior seal to protect electrical contacts and components from dirt and moisture in harsh environments. Be sure to follow manufacturer's instructions when using the UltraTorch UT-100 or any other radiant heating device. Failure to follow manufacturer's instructions can cause a fire, which could result in death or serious injury. (00335a) The left handlebar switches include the headlamp HI - LO switch, horn and left turn signal switch. The right handlebar switches include the engine start and RUN - OFF switch and right turn signal switch.

The individual switches are non- repairable and must be replaced if they malfunction. • Avoid directing heat toward any fuel system component. Extreme heat can cause fuel ignition/explosion resulting in death or serious injury. NOTES • Avoid directing heat toward any electrical system com- ponent other than the connectors on which heat shrink work is being performed. • On certain models, the turn signal wiring is routed through the lower switch housings and handlebars. • To replace or repair individual switches in either the right or left handlebar switch assemblies, see 7.30 RIGHT HANDLEBAR SWITCH or 7.31 LEFT HANDLEBAR SWITCH .

• Always keep hands away from tool tip area and heat shrink attachment. 6. See Figure 7-59 . Using the ULTRA TORCH UT-100 (Part No. HD-39969) or ROBINAIR HEAT GUN (Part No. HD- 25070) with HEAT SHIELD ATTACHMENT (Part No. HD- 41183) or other suitable radiant heating device, uniformly heat the heat-shrink tubing to insulate and seal the soldered connections. Apply heat just until the meltable sealant exudes out both ends of tubing and it assumes a smooth cylindrical appearance. REPAIR PROCEDURES TOOL NAME PART NUMBER ROBINAIR HEAT GUN HD-25070 ULTRA TORCH UT-100 HD-39969 HEAT SHIELD ATTACHMENT HD-41183 7. Inspect the melted sealant for solder beads.

Excess solder or heat may force some solder out with the melted sealant. Use a small needle nose pliers to remove any solder found. Briefly heat the connection to reseal the tubing if solder beads were removed. Use less solder or reduce heating time or intensity when doing subsequent splices. See 7.30 RIGHT HANDLEBAR SWITCH and 7.31 LEFT HANDLEBAR SWITCH . The removal and installation steps listed apply when replacing the entire switch assembly, switch housing or handlebars. The information below is useful when repairing handlebar switch assemblies. 1.

To better access wires and avoid damaging conduit with radiant heating device, push conduit back and secure with extra 177.8 mm (7.0 in.) cable strap in kit. Be sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury. (00316a) 2. Strip 12.7 mm (0.5 in) of insulation off switch wires. Twist coiled. 3. of new switch assembly. 4. Splice existing and wire at a time. 5. ch wires until all strands are tightly rink tubing, supplied in repair kit into gments. Slide tubing over each wire bly. w switch wires, matching wire colors. nnections. For best results, do one k tubing over the soldered splices. 1.

Ultra Torch UT-100 2. Robinair Heat Gun 3. Heat Shield Attachme Figure 7-59. Radian e: Electrical nt t Heating Devices