HOME NOTE The friction shoe is a loose fit and may fall out or become dis- lodged if the lower switch housing is turned upside down or shaken. Do not remove or install the master cylinder assembly without first positioning a 5/32-inch (4 mm) thick insert between the brake lever and lever bracket. Removing or installing the master cylinder assembly without the insert in place may result in damage to the rubber boot and plunger on the front stoplight switch. (00324a) 7. See Figure 7-62 . Push the throttle and idle control cables into the lower switch housing until they snap in place. Note the different diameter inserts crimped into the end of the throttle and idle cable housings. a.
Push the silver insert of throttle cable housing into the hole in front of tension adjuster screw. sm00995 b. Push the gold insert (1) of idle cable housing into the hole at the rear of tension adjuster screw. NOTE To aid assembly, place a drop of light oil on the retaining rings of the crimped inserts. Always replace the retaining rings if damaged or distorted. 1 2 grooves molded into the grip. Figure 7-64.Throttle Cable Installation 11. Position the upper switch housing over the handlebar and lower switch housing. 12. Verify that the wire harness conduit runs in the depression at the bottom of the handlebar.
Be sure that the upper switch housing harness will not be pinched under the handlebar when the switch housing screws are tightened. 13. Start the upper and lower switch housing screws, but do not tighten. 7-50 2009 VRSC Service: Electrical sm01031 1 2 3 1. Idle cable insert (gold insert, rear hole) 2. Throttle cable insert (silver insert, front hole) 3. Tension adjuster screw Figure 7-62. Right Lower Switch Housing 8. See Figure 7-63. Route the cable to the upper switch housing as shown. 9. Slide the throttle control grip over the end of the right handlebar until it bottoms against the closed end. Rotate the grip so that the ferrule notches are at the top.
To pre- vent binding, pull the grip back about 3.2 mm (1/8 in.). 10. See Figure 7-64. Position lower switch housing beneath the throttle control grip. Install the brass ferrules onto the cable so that the end fittings seat in the ferrule recess. Seat the ferrules in their respective notches on the throttle control grip. Verify that the cables are captured in the 1. End fittings 2. Upper switch housing cable Figure 7-63. Route Cable to Upper Switch Housing sm01084 3 4 2 5 1 1. Throttle cable (silver insert, front hole) 2. Groove in throttle grip 3. Notch 4. Brass ferrule 5. Idle cable (gold insert, rear hole)