HOME sm01085 sm01086 1 1 4 3 2 2 1. Groove 2. 4 mm (5/32 in.) cardboard insert Figure 7-65. Leave Cardboard Insert in Place 1. Switch housing assembly 2. Tab 3. Groove 4. Brake lever bracket 14. See Figure 7-66 . Position the brake lever/master cylinder assembly inboard of the switch housing assembly, enga- ging the tab on the lower switch housing in the groove at the top of the brake lever bracket. Figure 7-66. Switch Housing Alignment (typical) 15. Align the holes in the handlebar clamp with those in the death or serious injury. (00316a) 18. Replace the main fuse. Replace the right side cover. Figure 7-67. Handlebar Clamp Screws (typical) 19. Replace the left side cover. 20.
Test the switches for proper operation. DISASSEMBLY Do not remove or install the master cylinder assembly without first positioning a 5/32-inch (4 mm) thick insert between the brake lever and lever bracket. Removing or installing the master cylinder assembly without the insert in place may result in damage to the rubber boot and plunger on the front stoplight switch. (00324a) 1. Place the cardboard insert between the brake lever and lever bracket. 2. Using a T25 TORX drive head, remove the upper and lower switch housing screws. 2009 VRSC Service: Electrical 7-51 master cylinder housing and start the two screws (with flat washers). Position for rider comfort.
Beginning with the top screw, tighten to 6.8-9.0 Nm (60-80 in-lbs) using a T27 TORX drive head. 16. Using a T25 TORX drive head, tighten lower and upper switch housing screws to 4.0-5.1 Nm (35-45 in-lbs). NOTE Always tighten the lower switch housing screw first so that any gap between the upper and lower housings is at the front of the switch. 17. Remove the cardboard insert between the brake lever and lever bracket. Be sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in sm00996 1 2 1. Upper screw 2. Lower screw and flat washer