2009 — Switch Repair/Replacement

HOME 3. If replacing lower housing switches, perform steps 4 through 7 before continuing to repair section. If replacing upper housing switches, proceed directly to repair section. 9. See Figure 7-68 . Install screw and lockwasher (4) to secure bracket (5) inside housing. Verify that wing on engine stop switch (2) side of bracket captures edge of conduit (3) as shown. 4. See Figure 7-67 . Using a T27 TORX drive head, loosen the upper screw (1) securing the handlebar switch clamp to the master cylinder housing. Remove the lower clamp screw with flat washer (2). 10. Securely tighten cable strap to draw splices to bracket. Remove any excess cable strap material. 11.

Continue with 7.30 RIGHT HANDLEBAR SWITCH, 5. Remove the brass ferrules from the notches on the inboard side of the throttle control grip. Remove the ferrules from Assembly . 3. Slide conduit forward over cut ends of switch wires and cut off 12.7 mm (0.5 in.) of conduit (3) material. Push conduit back to access switch wires. Figure 7-68. Upper Housing Without Splices 4. See Figure 7-69 . Separate new engine stop switch (2) and engine start switch (1) wires into two bundles. NOTE Replacement stop switch and start switch wires are cut to length, 63.5 mm (2.5 in.) and 50.8 mm (2.0 in.) respectively, and partially stripped. 5.

See 7.29 HANDLEBAR SWITCH ASSEMBLIES for information on splicing and general repair practices. 6. Loop switch wires so that spliced lengths are positioned as shown in Figure 7-69 . Route wires downstream of splices beneath wing on engine stop switch side of bracket as shown in Figure 7-68 . 7. See Figure 7-69 . Install a new 177.8 mm (7.0 in.) cable strap (5) beneath wing on engine start switch side (1) of bracket and capture wire splices (4). 8. Place switch assembly into upper housing aligning hole in bracket with threaded hole in boss. Be sure that bracket is fully seated.

The step at the edge of the boss captures the bottom edge of the bracket, while tabs on each side of the bracket fit in slots cast into the housing. 7-52 2009 VRSC Service: Electrical 6. Remove the friction shoe from the end of the tension adjuster screw. NOTE The friction shoe is a loose fit and may fall out or become dis- lodged if the lower switch housing is turned upside down or shaken. 7. Remove the throttle control grip from the end of the handlebar. SWITCH REPAIR/REPLACEMENT Upper Housing Repair NOTE Replace the engine stop and engine start switches as a single assembly even if only one switch is determined to be faulty. 1. See Figure 7-68.

From inside the switch housing, remove the screw with lockwasher (4) to release the bracket (5). Remove the bracket and switch assembly from the housing. 2. Move cable conduit (3) from beneath wing of bracket. Cut wires 6.4 mm (0.25 in.) from old switches (1, 2). Discard old switch and bracket assembly. sm01091 1 2 5 4 3 1. Horn switch 2. High/low beam switch 3. Conduit 4. Screw with lockwasher 5. Bracket