2009 — Switch Repair/Replacement

HOME sm01088 3. Cut wires 25.4 mm (1.0 in.) from old switch. Discard old switch. NOTE Replacement stoplight switch wires are cut to length of 63.5 mm (2.5 in.) and partially stripped. 1 2 4. See 7.29 HANDLEBAR SWITCH ASSEMBLIES for information on splicing and general repair practices. 5. Carefully depress plunger against inside wall of switch housing. With thumb over plunger bore, move switch into the installed position in the switch housing cavity. When plunger is positioned against thumb, slowly rotate switch downward while rocking slightly. Release the plunger only after switch is properly positioned in the cavity. 5 4 3 6.

Verify that the plunger is square in the bore and that the boot is not compressed, collapsed or torn. If necessary, gently work the plunger in and out until boot is fully extended. 7. See Figure 7-70 . Push down on switch (1) so that it bot- toms against housing and wires (3) run in groove at base of cavity. With the concave side facing outward, insert wedge (2) between switch and outboard side of switch housing. 1. Start switch 2. Stop switch 3. Conduit 4. Splices 5. Cable strap 8. Push wedge down until it also bottoms against housing. Verify that the plunger is still square in the bore and then place a drop of RTV Silicone Sealant on upper corner of wedge. Figure 7-69.

Upper Housing With Splices Lower Housing Repair 9. Continue with 7.30 RIGHT HANDLEBAR SWITCH, Assembly. 1. From inside the switch housing, carefully cut cable strap to free conduit from the turn signal switch bracket. sm01089 2. Remove the screw with lockwasher to release the turn signal switch bracket. Remove the bracket and switch assembly from the housing. 3. Continue with TURN-RIGHT SIGNAL SWITCH or FRONT STOPLIGHT SWITCH procedures which follow. Turn-Right Signal Switch 4 1 1. Perform steps in LOWER HOUSING REPAIR. 2 2. Cut wire 38.1 mm (1.5 in.) from old switch. Discard old switch assembly.

NOTE Replacement turn-right signal switch wires are cut to length of 38.1 mm (1.5 in.) and partially stripped. 3. See 7.29 HANDLEBAR SWITCH ASSEMBLIES for 3 information on splicing and general repair practices. 4. Continue with 7.30 RIGHT HANDLEBAR SWITCH, Assembly. Front Stoplight Switch 1. Perform steps in LOWER HOUSING REPAIR. 1. Stoplight switch 2. Carefully remove the wedge between the switch and switch 2. Wedge housing, if present.To remove the switch from the housing, 3. Switch wires depress the plunger and slowly rotate switch upward while 4. Lower switch housing rocking slightly. Figure 7-70. Install Stoplight Switch 2009 VRSC Service:

Electrical 7-53 sm01089 4 1 2 3 WER HOUSING REPAIR. 1. Stoplight switch wedge between the switch and switch 2. Wedge o remove the switch from the housing, 3. Switch wires and slowly rotate switch upward while 4. Lower switch housing Figure 7-70. Install Sto 2009 VRSC 1. Stoplight switch 2. Wedge 3. Switch wires 4. Lower switch housing plight Switch Service: Electrical 7-53