HOME ASSEMBLY angular arm of bracket downward to firmly secure front stoplight switch in position. 1. See Figure 7-71 . Insert tapered end of new 177.8 mm (7.0 in.) cable strap (1) into round hole in turn signal switch bracket (2) and then feed back through using the adjacent hole. Reserve the oblong hole for the bracket screw. 9. See 7.30 RIGHT HANDLEBAR SWITCH, Installation . a. If lower housing switches were replaced, perform the entire procedure. NOTE Be sure that all splices are positioned above the turn signal switch bracket. b. If upper housing switches were replaced, begin with step 11. any excess cable strap material. If necessary, bend Figure 7-71.
Insert Cable Strap in Switch Bracket 7-54 2009 VRSC Service: Electrical 2. Place the turn signal switch assembly into the housing, aligning the oblong hole in the bracket with the threaded hole in the boss. Be sure that the bracket is fully seated. Tabs on each side of bracket are captured in slots cast into switch housing. 3. Start screw with lockwasher to secure bracket inside housing. If routed incorrectly, wires can be pinched by casting or handlebar resulting in switch failure. (00542b) 4. Loop switch wires so that spliced lengths are positioned across bracket. 5. Capturing conduit about 6.4 mm (0.25 in.) from end, securely tighten cable strap to draw conduit to bracket.
Remove any excess cable strap material. 6. Install second 177.8 mm (7.0 in.) cable strap capturing conduit and wire splices. Securely tighten cable strap to draw splices to conduit. Remove any excess cable strap material. 7. Tighten screw to secure bracket inside housing. 8. Route wire bundle to upper switch housing by gently pressing conduit into channel next to angular arm of bracket. Secure bundle to arm using third cable strap. Cut sm01090 1 2 3 pturing trap to e strap 1. Cable strap 2. Bracket 3. Right turn signal switch