HOME 7.31 LEFT HANDLEBAR SWITCH REMOVAL NOTE sm00998 The removal and installation steps listed apply when replacing a switch housing and its wire harness. Replacing a switch housing alone, repairing a switch housing, or replacing handlebars will not require removal of the wire harness to the switch housing. 1. Remove maxi-fuse. See 7.4 MAXI-FUSE . 2 2. See Figure 7-72 . If removing the switch housing and wire harness, remove the left side cover and locate the left switch housing connector [24]. 1 3. Depress the latch on the socket housing and separate the switch housing connector halves. 3 4.
Remove secondary locking wedge and depress terminal latches inside socket housing to remove socket terminals and wires. 5. Using a T27 TORX drive head, remove the two screws with flat washers securing the handlebar clamp to the clutch lever and master cylinder bracket. Remove the clutch hand lever assembly and clamp from the handlebar. 1. Grip sleeve 2. Ribs 3. Grooves Figure 7-73. Left Handlebar Switch Housings 6. Using a T25 TORX drive head, remove the upper and lower switch housing screws. handlebar clips. Wrap the free ends of the wire harness to the wire lead and pull through the opening in the upper fork clamp. Figure 7-72. Left Switch Housing Connector [24] (typical) 2.
Route wire harness around steering head. 3. Crimp socket terminals on ends of wire and push through connector wire seal and into socket housing. 4. Install internal seal and locking wedge. 2009 VRSC Service: Electrical 7-55 7. Remove the grip sleeve from the end of the handlebar if damaged. 8. To remove the housing with the wire harness, wrap switch housing wires to wire lead and pull wires through opening in upper fork clamp. Leave wire lead in fork clamp. 9. Pull the wire harness through the handlebar clips and remove the housing and wire harness. sm00997 lebar if switch pening sm00999 1 2 3 4 1. Clutch lever bracket 2. Groove 3. Tab 4. Switch housing assembly Figure 7-74.
Clutch Lever Bracket INSTALLATION 1. Thread the lose ends of the wire harness through the