2009 — Assembly

HOME bracket (2) and then feed back through using the adjacent hole. Reserve the oblong hole for the bracket screw. 9. Verify the operation of the clutch interlock switch. See the ELECTRICAL DIAGNOSTIC MANUAL. NOTE Be sure that all splices are positioned above the turn signal switch bracket. sm01094 2. Place the turn signal switch assembly (3) into the housing, aligning the oblong hole in the bracket with the threaded hole in the boss. Be sure that the bracket is fully seated. Tabs on each side of bracket are captured in slots cast into switch housing. 1 2 3. Start screw with lockwasher to secure bracket inside housing.

If routed incorrectly, wires can be pinched by casting or handlebar resulting in switch failure. (00542b) 4. Loop switch wires so that spliced lengths are positioned across bracket. 5. Capturing conduit about 6.4 mm (0.25 in.) from end, securely tighten cable strap to draw conduit to bracket. Remove any excess cable strap material. 6. Tighten screw to secure bracket inside housing. 3 7. Route wire bundle to upper switch housing below and then forward of the main wire harness, positioning conduit in channel next to angular arm of bracket. Secure bundle to arm using new cable strap. Cut any excess cable strap material. 1. Cable strap 2. Bracket 3. Left turn signal switch 8.

See 7.31 LEFT HANDLEBAR SWITCH, Installation . Figure 7-78. Insert Cable Strap in Switch Bracket a. If lower housing switches were replaced, perform the whole procedure. b. If upper housing switches were replaced, begin with step 7. 7-58 2009 VRSC Service: Electrical