2009 — Assembly

HOME sm01091 2. Remove screw with lockwasher to release the turn signal switch bracket. Remove the bracket and switch assembly from the housing. 3. Continue with TURN-LEFT SIGNAL SWITCH or CLUTCH INTERLOCK SWITCH procedures. 1 2 Turn-Left Signal Switch 1. Perform steps in LOWER HOUSING REPAIR. 2. Cut wires 38.1 mm (1.5 in.) from old switch (Turn-L(eft) Signal Switch). Discard switch assembly. 5 4 NOTE Replacement turn-right signal switch wires are cut to length of 38.1 mm (1.5 in.) and partially stripped. 3 3. See 7.29 HANDLEBAR SWITCH ASSEMBLIES for information on splicing and general repair practices. 4. Continue with 7.31 LEFT HANDLEBAR SWITCH, Assembly . 1. Horn switch 2.

High/low beam switch 3. Conduit 4. Screw with lockwasher 5. Bracket Clutch Interlock Switch 1. Perform steps in LOWER HOUSING REPAIR. 2. See Figure 7-77 . Cut wires 6.4 mm (0.25 in.) from old switch. Discard switch assembly. Figure 7-75. Upper Housing Without Splices NOTE Replacement turn-right signal switch wires are cut to length and partially stripped. 3. See 7.29 HANDLEBAR SWITCH ASSEMBLIES for information on splicing and general repair practices. sm01092 4. Continue with 7.31 LEFT HANDLEBAR SWITCH, Assembly . 1 2 sm02644 4 3 5 1. Horn switch 2. High/low beam switch 3. Conduit 4. Splices 5. Cable strap Figure 7-76. Upper Housing With Splices Lower Housing Repair ASSEMBLY 1.

From inside the switch housing, carefully cut cable strap to free conduit from the turn signal switch bracket. 1. See Figure 7-78 Switch of new 177.8 mm in turn signal switch e: Electrical 7-57