2009 — AMP Multilock Connector Repair

HOME A.1 AMP MULTILOCK CONNECTORS AMP MULTILOCK CONNECTOR REPAIR TOOL NAME PART NUMBER sm00002 AMP MULTILOCK CRIMPER HD-41609 2 3 PICK SNAP-ON TT600-3 General 4 AMP Multilock connectors are found between wire harnesses and component wiring and may be either floating or anchored to the frame with attachment clips. See Figure A-1 . Attachment clips (1) on the pin housings are fitted to T-studs on the motorcycle frame. The T-studs identify OE connector locations. To maintain serviceability, always return connectors to OE locations after service. Obtain the necessary tools to repair the connector and ter- minals. NOTE For terminal crimping use the AMP MULTILOCK CRIMPER (Part No. HD-41609).

1 Separating Pin and Socket Housings 1. If necessary, slide connector attachment clip T-stud to the large end of the opening. 1. Attachment clip 2. Release button 3. Socket housing 4. Pin housing 2. See Figure A-1 . Depress the release button (2) on the socket terminal side of the connector and pull the socket housing (3) out of the pin housing (4). Figure A-1. AMP Multilock Connector Mating Pin and Socket Housings Removing Terminals from Housing 1. Hold the housings to match wire color to wire color. 2. Insert the socket housing into the pin housing until it snaps in place. 1. See Figure A-2 . Bend back the latch (1) to free one end of secondary lock (2) then repeat on the opposite end.

Hinge the secondary lock outward. 3. If OE location is a T-stud, fit large opening end of attach- ment clip over T-stud and slide connector to engage T- stud to small end of opening. 2. Look in the terminal side of the connector (opposite the secondary lock) and note the cavity next to each terminal. 3. Insert a pick or pin into the terminal cavity until it stops. NOTE If socket/pin terminal tool is not available, a push pin/safety pin or a PICK (Part No. SNAP-ON TT600-3) may be used. 4. Press the tang in the housing to release the terminal. a. Socket: Lift the socket tang (8) up. b. Pin: Press the pin tang (7) down. NOTE A "click" is heard if the tang is released. 5.

Gently tug on wire to pull wire and terminal from cavity. 2009 VRSC Service: Appendix A Connector Repair A-1