2009 — AMP Multilock Connector Repair

HOME NOTES sm00013 • Up and down can be determined by the position of the release button, the button is the top of the connector. • On the pin side of the connector, tangs are positioned at the bottom of each cavity, so the slot in the pin terminal (on the side opposite the crimp tails) must face downward. • On the socket side, tangs are at the top of each cavity, so the socket terminal slot (on the same side as the crimp tails) must face upward. 5 7 2. Gently tug on wire end to verify that the terminal is locked in place. 2 3. Rotate the hinged secondary lock inward until tabs fully 3 engage latches on both sides of connector. 1 sm00005 2 1 4 – AMP 1 2 3 1 6 2 8 – AMP 1 2 3 4 5 6 1 2 3 4 1.

Latch 2. Secondary lock open 3. Pin housing 4. Socket housing 3 5. Pin terminal 6. Socket terminal 7. Tang (pin) 8. Tang (socket) Figure A-2. AMP Multilock Connector: Socket and Pin 5 6 7 8 9 10 Housings 1. 3-place housing Inserting Terminals into Housing 2. 6-place housing 3. 10-place housing NOTE Figure A-3. AMP Multilock Connector: Cavity Numbers on See Figure A-3. Cavity numbers are stamped into the sec- Secondary Locks (Socket Housings Shown) ondary locks of both the socket and pin housings. Match the wire color to the cavity number found on the wiring diagram. 1. Hold the terminal so the catch faces the tang in the Preparing Wire Leads for Crimping chamber.

Insert the terminal into its numbered cavity until 1. Strip 4.0 mm (5/32 in.) of insulation from the wire lead. it snaps in place. A-2 2009 VRSC Service: Appendix A Connector Repair Figure A-3. AMP Multilock Conn stamped into the sec- Secondary Locks (Socke in housings. Match the n the wiring diagram. faces the tang in the Preparing Wire Leads f s numbered cavity until 1. Strip 4.0 mm (5/32 in.) of ins A Connector Repair ector: Cavity Numbers on t Housings Shown) or Crimping ulation from the wire lead.