2009 — AMP Multilock Connector Repair

HOME 2. See Figure A-2 and Figure A-5 . Select the pin/socket ter- minals from the parts catalog and identify the insulation crimp tails (1) and the wire crimp tails (2) and the groove for the crimp tool locking bar (3). 1. See Figure A-6 . Squeeze the handles to cycle the AMP MULTILOCK CRIMPER (Part No. HD-41609) to the fully open position (1). 2. Raise locking bar by pushing up on bottom flange (2). 3. Identify the wire lead gauge and the corresponding crimper tool and nesting die. Refer to Table A-1 . NOTE See Figure A-2 and Figure A-5 .

Hold the terminal with the insulation crimp tail (1) facing up.The tool will hold the terminal by the locking bar groove (3) and crimp the wire crimp tail (2) around the bare wire of the stripped lead and the insulation crimp tail around the insulation. Table A-1. AMP Multilock Connector: Crimp Tool Wire Gauge/Nest NEST WIRE GAUGE Front 20 3. See Figure A-6 . With the insulation crimp tail facing upward, insert terminal (pin or socket) (3) through the locking bar, so that the closed side of the terminal rests on the nest of the crimp tool. Middle 16 Rear 18 4. Release locking bar to lock position of contact (4).

When correctly positioned, the locking bar fits snugly in the space at the front of the core crimp tails. 5. Insert stripped end of lead (5) until ends make contact with locking bar. 6. Verify that wire is positioned so that wire crimp tails squeeze bare wire strands, while insulation crimp tails fold over the wire lead insulation. 7. Squeeze handle of crimp tool until tightly closed. Tool automatically opens when the crimping sequence is com- plete. 8. Raise up locking bar (7) and remove crimped terminal. sm00001 1 3 2 1. Insulation crimp tail 2. Wire crimp tail 3. Locking bar groove Figure A-5. AMP Multilock Connector:

Socket Terminal Crimping Terminals to Leads NOTE Crimping with an Amp Multilock tool is a one step operation. One squeeze crimps both the wire core and the insulation tails. 2009 VRSC Service: Appendix A Connector Repair A-3 sm00004 1 3 2 1. Insulation crimp tail 2. Wire crimp tail 3. Locking bar groove 1. Insulation crimp tail 2. Wire crimp tail 3. Locking bar groove Figure A-4. AMP Multilock Connector: Pin Termi