2009 — Delphi Connector Repair

HOME A.3 DELPHI CONNECTORS DELPHI CONNECTOR REPAIR General sm00014 Delphi connectors are embossed with the brand name, Delphi, on the housing latch. Separating Pin and Socket Housings See Figure A-10 . Bend back the external latch(es) slightly and separate pin and socket halves of connector. Mating Pin and Socket Housings Push pin and socket halves of connector together until external latch(es) engage. Removing Socket Terminals NOTE Although the parts of the different Delphi connectors vary in appearance, the instructions which follow will work for all.

The only exception is the oil pressure sender connector [139B], the terminals of which are removed like the Packard push-to-seat connectors.Therefore, see A.11 PACKARD 150 METRI-PACK CONNECTORS to remove/install terminals in this connector. 1. See Figure A-11 . If present, free one side of wire lock (1) from ear on wire end of socket housing, then release the remove from socket housing. Figure A-10. Delphi Connector: Socket Housing Latch 2. 3. hobby knife, gently pry tang (3) outward away from ter- minal, and then tug on wire to back terminal out wire end of chamber. Do not pull on wire until tang is released or terminal will be difficult to remove.

Installing Socket Terminals NOTE For wire location purposes, alpha or numeric characters are stamped into the wire end of each socket housing. 1. Gently push tang on socket housing inward toward chamber. With the open side of the terminal facing the tang, push terminal into chamber at wire end of socket housing. 2. Gently tug on wire to verify that terminal is locked and will not back out of chamber. If necessary, use fingernail to push tang into engagement with terminal. 3. Install colored terminal lock onto mating end of socket housing. 4. If present, seat wires in separate channels of wire lock and then push channels inside chambers at wire end of socket housing.

Fully installed, slot on each side of wire lock engages ear on socket housing. A-6 2009 VRSC Service: Appendix A Connector Repair hannels in wire lo rminal lock (2) loo socket housing. unsharpened ed ck and se and ge of a