2009 — Deutsch 1-Place Connector Repair

HOME A.5 DEUTSCH 1-PLACE ELECTRICAL CONNECTORS Figure A-15. Deutsch 1-Place Connector: Remove Socket/Pin Housing A-10 2009 VRSC Service: Appendix A Connector Repair Separating Pin and Socket Housings Depress external latch and separate the pin and socket hous- ings of the Deutsch one place connector found on voltage regulators. Mating Pin and Socket Housings Orient the housings so the latch faces the catch and push the housings together until it clicks. Removing Socket Terminals NOTE Rough handling or careless storage can result in tool damage. Exercise care to avoid cracking or breaking the thin plastic construction. 1.

Pull rear wire seal from back of housing and slide down voltage regulator cable to move out of the way. 2. See Figure A-15. Using terminal pick tool (Deutsch® 114008) (1), install tool onto voltage regulator cable so that the tapered end is in the wire end of the housing (2). 3. Push tool into wire end of housing until it bottoms. Gently tug on housing to pull from terminal (3). 4. Remove tool from voltage regulator cable. Installing Socket Terminals 1. Insert terminal into wire end of housing until it "clicks" in place. Verify that terminal will not back out of housing. A slight tug on the voltage regulator cable will confirm that it is properly locked in place. 2.

Fit rear wire seal into back of housing. sm00016 1 2 3 1. Deutsch terminal pick tool (114008) 2. Tool installed in housing 3. Terminal removed from housing