2009 — Deutsch Connector Repair

HOME A.6 DEUSCH ELECTRICAL CONNECTORS DEUTSCH CONNECTOR REPAIR 4. Place large end of slot on attachment clip over T-stud on frame. Push assembly forward to engage small end of slot. TOOL NAME PART NUMBER DEUTSCH CONNECTOR SERVICE KIT HD-41475 FLAT BLADE L-HOOK HD-41475-100 sm00017 General Deutsch connectors are colored coded for location purposes. Those connectors associated with left side accessories, such as the front and rear left turn signals, are gray . All other con- nectors, including those associated with right side accessories, are black . 3 1 NOTE A DEUTSCH CONNECTOR SERVICE KIT (Part No.

HD- 41475) contains a selection of wire seals, internal seals, seal plugs, secondary locking wedges, attachment clips and socket/pin terminals. Also included is a compartmented storage box, carrying case and a FLAT BLADE L-HOOK (Part No. HD- 41475-100) is used for the removal of all types of locking wedges. 2 1 Separating Pin and Socket Housings See Figure A-15 . To separate the connector halves, depress the external latch(es) (1) on the socket housing (2) while rocking the pin (3) and socket housings. 1. External latch 2. Socket housing 3. Pin housing NOTES Figure A-16.

Deutsch Connector • Generally, the socket housing is found on the accessory side, while the pin housing is plumbed to the wiring har- ness. Removing Socket Terminals 1. See Figure A-17 . Insert a small screwdriver between the socket housing and locking wedge in-line with the groove (in-line with the pin holes if the groove is absent).Turn the screwdriver 90 degrees to pop the wedge up and remove the secondary locking wedge. • Two-, three-, four- and six-place Deutsch connectors have one latch on the connector. • Eight- and twelve-place connectors have a latch on each side. Simultaneously press both latches to separate the connector. 2. See Figure A-20 .

Use a pick or small screwdriver to depress terminal latches inside socket housing and back out sockets through holes in rear wire seal. Mating Pin and Socket Housings 1. Align the connectors to match the wire lead colors. a. For One External Latch: Two-, three-, four- and six- place Deutsch connectors have one external latch on the socket half of the connector. To fit the halves of the connector together, the latch on the socket side must be aligned with the latch cover on the pin side. NOTE If wire leads require new terminals, see the instructions for crimping terminals. b. For Two External Latches:

(8-place and 12-place) Align the tabs on the socket housing with the grooves on the pin housing. Installing Socket Terminals 1. Match wire lead color to connector cavity. 2. See Figure A-19 . Fit rear wire seal (1) into back of socket housing (2), if removed. 2. Insert socket housing into pin housing until it snaps or clicks into place. 3. Grasp wire lead (3) approximately 25.4 mm (1.0 in.) behind the socket terminal. Gently push socket through hole in wire seal into its chambers until it "clicks" in place. For Two External Latches:

(8-place and 12-place) If latches do not click (latch), press on one side of the con- nector until that latch engages, then press on the opposite side to engage the other latch. 4. A tug on the wire will confirm that it is properly locked in place. 3. If necessary, fit the attachment clip to the pin housing. 2009 VRSC Service: Appendix A Connector Repair A-11