HOME in place. Figure A-19. Deutsch Connector: 2, 3, 4 and 12-Place Socket Housings NOTE A tug on the wire lead will confirm that a pin is locked in place. Removing Pin Terminals 3. Insert tapered end of secondary locking wedge (4) into pin housing and press down until it snaps in place. 1. Use the hooked end of a stiff piece of mechanics wire, a needle nose pliers or the FLAT BLADE L-HOOK (Part No. HD-41475-100) to remove the secondary locking wedge. NOTES • The wedge fits in the center groove of the pin housing and holds the terminal latches tightly closed. 2. Gently depress terminal latches inside pin housing and back out pins through holes in wire seal.
• See Figure A-18 .While rectangular wedges do not require a special orientation, the conical secondary locking wedge of the 3-place connector must be installed with the arrow (2) pointing toward the external latch. • If wire leads require new terminals, see the instructions for crimping terminals. NOTES • If the secondary locking wedge does not slide into the installed position easily, verify that all terminals are fully installed in the pin housing. The lock indicates when ter- minals are not properly installed by not entering its fully installed position.
• If it should become necessary to replace a pin or socket housing, please note that the 8-place and 12-place gray and black connectors are not interchangeable. Since loc- 2009 VRSC Service: Appendix A Connector Repair A-13 sm00010 DEUTSCH 5 6 4 2 1 3 1. Wire seal 2. Socket housing 3. Wire lead 4. Internal seal 5. Secondary locking wedge 6. Seal plug ation of the alignment tabs differ between the black and gray connectors, plugs or receptacles must be replaced by those of the same color.
• When replacing both socket and pin housings, then the black may be substituted for the gray, and vice versa.The socket and pin housings of all other connectors are inter- changeable, that is, the black may be mated with the gray, since the alignment tabs are absent and the orientation of the external latch is the same. sm00019 Figure A-20. Deutsch Connector: Depress Terminal Latch and Back Out Pin Installing Pin Terminals 1. See Figure A-21. Fit wire seal (1) into back of pin housing (2). 2. Grasp wire lead approximately 25.4 mm (1.0 in.) behind the pin terminal (3). Gently push pin through holes in wire seal into its respective numbered chamber until it "clicks"