2009 — Deutsch Mini Terminal Crimps

HOME A.7 DEUTSCH MINI-TERMINAL CRIMPS DEUTSCH MINI TERMINAL CRIMPS Inspecting Crimps TOOL NAME PART NUMBER Inspect the core and insulation crimps. Distortion should be minimal. PACKARD TERMINAL CRIMPER HD-38125-7 1. 2. 3. 4. 5. 6. 7. Figure A-22. Packard Terminal Crimper (HD-38125-7) 2009 VRSC Service: Appendix A Connector Repair A-15 paring Wire Leads for Crimping wire lead removing 4.0 mm (5/32 in.) of insulation. mping a Mini Terminal to Wire Lead See Figure A-22. Compress the handles of PACKARD TERMINAL CRIMPER (Part No. HD-38125-7) until the ratchet (2) automatically opens. NOTE ys perform core crimp before insulation crimp. Position the core crimp on die E (1) of the crimper.

Be sure the core crimp tails are facing the forming jaws. Gently apply pressure to handles of tool until crimpers just secure the core crimp tails. Insert stripped wire core stands between crimp tails. Pos- ition wire so that short pair of crimp tails squeeze bare wire strands, while long pair squeeze over the insulation. Squeeze handle of crimper until tightly closed. Tool auto- matically opens when the crimping sequence is complete. NOTE crimper does not open, it can be opened by squeezing atchet trigger (2). Position the insulation crimp on nest C of the crimper. Be sure the insulation crimp tails are facing the forming jaws. Squeeze handle of crimp tool until tightly closed.

Tool automatically opens when the crimping sequence is com- plete. sm00022 1 2 1. E die 2. Crimper ratchet trigger