2009 — Deutsch Standard Terminal Crimps

HOME A.8 DEUTSCH STANDARD TERMINALS DEUTSCH STANDARD TERMINAL CRIMPS straight upward. When positioned, the locking bar fits snugly in the space between the contact band and the core crimp tails. TOOL NAME PART NUMBER DEUTSCH TERMINAL CRIMP TOOL HD-39965-A 4. Insert stripped wire core between crimp tails until ends make contact with locking bar.Verify that wire is positioned so that short pair of crimp tails squeeze bare wire strands, while long pair folds over the insulation. Preparing Wire Leads for Crimping 1. Use a shop gauge to determine gauge of wire lead. 5. Squeeze handle of crimp tool until tightly closed. Tool automatically opens after the terminal is crimped. 2.

Strip lead removing 4.0 mm (5/32 in.) of insulation. 6. Raise locking bar up and remove wire lead and terminal. Crimping Terminal to Lead 1. See Figure A-23 . Squeeze the handles of the DEUTSCH TERMINAL CRIMP TOOL (Part No. HD-39965-A) to open the jaws. Push the locking bar (1) up. Inspecting Crimps Inspect the wire core and insulation crimps. Distortion should be minimal. 2. Insert (2) terminal (socket/pin) through hole of the locking bar, so that the rounded side of the contact barrel rests in the nest (concave split level area) with the crimp tails facing upward. To match the wire gauge to the crimp tool die, refer to Table A-3 . Table A-3.

Deutsch Standard Terminal Crimp:Wire Gauge To Die CRIMP TOOL DIE WIRE GAUGE (AWG) 3. Release locking bar to lock terminal in die. Front 20 NOTE If the crimp tails are slightly out of vertical alignment, the crimp tool automatically rotates the terminal so that the tails face Middle 16-18 sm00021 5 2 1 6 4 3 1. Open ja 2. Insert te 3. Release ws and raise locking bar 4. Insert stripped lead rminal in locking bar 5. Squeeze crimper locking bar to lock terminal in die 6. Raise locking bar and remo ve terminal A-16 2009 VRS Figure A-23. Crimping a Deutsch Standard Terminal C Service: Appendix A Connector Repair