HOME A.9 DEUTSCH SOLID BARREL TERMINALS Tool must be readjusted when changing contact size/type. 6. Install pin to lock selector knob. Figure A-24. Electrical Crimper Tool (HD-42879) Inspecting Crimps Inspect the crimp. All core wire strands are to be crimped in the barrel. 2009 VRSC Service: Appendix A Connector Repair A-17 DEUTSCH SOLID BARREL TERMINAL CRIMPS sm00023 PART NUMBER TOOL NAME HD-42879 ELECTRICAL CRIMPER TOOL Preparing Wire Leads For Crimping For size 20, 16 and 12 contacts, wire ranges 26-12 AWG. Strip wire lead removing 6.4 mm (1/4 in.) of insulation. Adjusting Crimper Tool 1. See Figure A-24. Squeeze the ELECTRICAL CRIMPER TOOL (Part No.
HD-42879) handles to cycle the crimp 3 tool to open. 2. Remove locking pin (1) from selector knob (2). 2 3. Raise selector knob and rotate until selected wire size stamped on wheel is aligned with "SEL. NO." arrow (3). 4. Loosen knurled locknut (4) and turn adjusting screw (5) clockwise (in) until it stops. Crimping a Barrel Contact To Wire Lead 1. See Figure A-25. Turn tool over and drop contact barrel (1) into indentor cover (2) hole with the wire end out. 2. Turn adjusting screw counterclockwise (out) until contact is flush with bottom of depression in indentor cover. Tighten knurled locknut. 3.
Slowly squeeze handles of crimp tool until contact is centered between the four indentor points (3). 4. Insert bare wire core strands of stripped wire lead (4) into contact barrel. Squeeze handle of crimp tool until tightly closed. Tool automatically opens when the crimping 1. Locking pi sequence is complete. 2. Selector k 3. SEL. NO. a 5. Remove wire lead with crimped contact from indentor. 4. Knurled lo NOTE 5. Adjusting 5 4 1 (46) t 1dy ebo 1 rn 2d t .e e 0s nw iu 1 fo 9m ep l yd1 sno R to aa F '' n CD i S dN SA sEHeA SH uR is "ePO Tbh n nob rrow cknut screw