HOME Table A-4. Crimp Tool Wire Gauge Punch/Die Position Terminal in the Punch/Die 1. See Figure A-33 .With the crimp tails up, place the terminal through the punch/die into the square opening in the socket locator bar. PUNCH/DIE AWG (WIRE GAUGE) Middle 18-20 Left 22 a. Socket Terminal: See Figure A-32 . A socket terminal stops against the back face of the socket locator bar (1). Right 14-16* * Crimp 16 AWG pin terminals in the 18-20 middle die. b. Pin Terminal: See Figure A-34 . The tip of a pin ter- minal passes through the socket locator bar and stops in the notch in the face of the pin locator bar. sm02853 2. See Figure A-35.
Ratchet the handles together until the crimp tails are held in vertical alignment between the punch and the die. sm02855 Figure A-31. Open Electrical Crimp Tool (HD-48119) at 45 Degrees Figure A-33. Square Openings in Socket Locator Bar sm02854 Insert Stripped Lead See Figure A-36. Insert the stripped end (wire core) between the crimp tails at an up angle until the wire core touches the 1 face of the socket locator bar above the square opening. 2 NOTES • The insulation must extend through the insulation crimp tails. • Insert the wire with little or no pressure. Pressing on the lead will bend the wire core. 1. Socket locator bar 2.
Pin locator bar Figure A-32.Terminal Locator Bars 2009 VRSC Service: Appendix A Connector Repair A-21 ar Terminal Locator Bars 2009 VRSC Service: Appendix A 1. Socket locator b 2. Pin locator bar Figure A-32.