2009 — Crimp Terminal to Lead

HOME sm02851 sm00044 1 3 Figure A-28. Pull Up Secondary Lock (Pin Housing) 2 sm00043 1. Cavity number 2. Tang 3. Cavity slot Figure A-30. Molex Connector: Pin Cavities and Wire Terminal CRIMP TERMINAL TO LEAD TOOL NAME PART NUMBER ELECTRICAL CRIMP TOOL HD-48119 Prepare Lead Figure A-29. Molex Connector:Terminal Remover (HD-48114) 1. Cut the damaged terminal close to the back of the terminal to leave as much wire length as possible. 2. Strip approximately 4.70-5.60 mm (3/16 in.) of insulation from the end of the wire lead. The strip length is the same for both pin and socket terminals and for wire gauges from 22 to 14. NOTE Prepare Tool 1.

Identify the punch/die in the jaws of the ELECTRICAL CRIMP TOOL (Part No. HD-48119) for the wire gauge. Refer to Table A-4 . 2. Squeeze and release the handles to open the tool. NOTE The crimp tool automatically opens when the handles are released. 3. See Figure A-31 . Hold fully open tool at approximately 45 degrees. NOTE Do NOT tighten the locknut holding the locator bars. The bars must float to accommodate the different terminal gauges. A-20 2009 VRSC Service: Appendix A Connector Repair