2009 — Packard Micro-64 Connector Repair

HOME A.17 PACKARD MICRO-64 CONNECTORS PACKARD MICRO-64 CONNECTOR REPAIR TOOL NAME PART NUMBER sm00046 PACKARD MICRO-64 TERMINAL REMOVER HD-45928 PACKARD MICRO-64 TERMINAL CRIMPER HD-45929 General Packard Micro-64 connectors are frequently found on speedometers, tachometers and the ECM of Touring Models. For pin 73 of these ECMs, see A.11 PACKARD 150 METRI- PACK CONNECTORS . Separating Pin and Socket Housings Bend back the external latches slightly and separate the pin and socket housings. Figure A-48. Packard Micro 64 Terminal Remover (HD-45928) Mating Pin and Socket Housings 1. 2. 3. 4. 5. 6. of the connector together until the latches click. sm00048 moving Terminal See Figure A-50.

Locate the head of the secondary lock (1) on one side of the connector housing. Insert the blade of a small screwdriver between the center ear of the lock and the connector housing and gently pry out lock.When partially removed, pull lock from connector housing. Locate pin hole (2) between terminals on mating end of connector. See Figure A-51. Obtain the PACKARD MICRO-64 TER- MINAL REMOVER (Part No. HD-45928). See Figure A-49. Push the adjacent terminals all the way into the connector housing and then insert tool into hole until it bottoms. Leaving the tool installed, gently tug on wires to pull either one or both terminals from wire end of connector. Remove tool. Figure A-49.

Packard Micro 64 Connector: Insert Tool and Remove Terminal 2009 VRSC Service: Appendix A Connector Repair Figure A-49. Packard Micro 64 Co Remove Term e: Appendix A Connector Repair nnector: Insert Tool and inal